.

Suzuki GS 500F

.  

Make Model

Suzuki GS 500F

Year

2007 -

Engine

Four stroke, parallel twin cylinder, DOHC

Capacity

487 cc / 29.7 cu in
Bore x Stroke 74 x 56.6 mm
Compression Ratio 9.0:1
Cooling System Air cooled

Induction

2 x 33mm Mikuni BST carburetors

Ignition

Transistorised electronig ignition

Starting

Electric

Max Power

38 kW / 51 hp @ 9500 rpm 

Max Torque

41.3 Nm / 4.2 kgf-m / 30.5 lb-ft @ 7500 rpm

Transmission

6 Speed

Final Drive

Chain

Frame

Steel, twin spar

Front Suspension

Telescopic forks, 7-way preload adjustment

Rear Suspension

Rising rate single shock, 7-way preload adjustment

Front Brakes

Single 310mm disc, 4 piston caliper

Rear Brakes

Single 250mm disc, 2 piston caliper

Front Tyre

110/70 H17

Rear Tyre

130/70 H17

Dimensions

Length: 2080 mm / 81.9 in
Width:    800 mm / 31.5 in
Height:  1150 mm / 45.3 in

Seat Height

790 mm / 31.1 in

Dry Weight

174 kg / 383 lbs

Wet Weight

199 kg / 439 lbs

Fuel Capacity 

20 Litres / 5.3 US gal / 4.4 Imp gal

Consumption Average

4.1 L/100 km / 24.5 km/l / 57.6 US mpg / 69.2 Imp mpg

Standing ¼ Mile  

14.8 sec

Top Speed

168.7 km/h / 105 mph

The Suzuki GS500 is an entry level motorcycle manufactured and marketed by the Suzuki Motor Corporation. Suzuki produced the GS500 and GS500E from 1989 on and the fully faired model, GS500F from 2004 on. The GS500 is currently being produced and sold in South America. The GS500 has been described in the motorcycle literature as a best buy and an excellent first bike, with adequate if not exciting power for more experienced riders (approximately 40 HP at the rear wheel).

The unfaired version of the GS500 was first sold in the UK in 1988 (model code GS500EJ) and the following year's model (code GS500EK) was released for sale in Europe and North America. It was equipped with an air-cooled parallel twin-cylinder engine derived from the earlier GS450. In the motorcycle market, the GS500 occupied the low end of Suzuki's mid-sized range for over twenty years.

Suzuki also produced GS500 models, identified by a 'U' suffix, with engines restricted to satisfy the maximum power-to-weight ratio for use in countries where restrictive motorcycle licenses were issued (the GS500 meets current EU and UK licence level A2 conditions without restricting the engine) or for countries with a Learner Approved Motorcycle program (such as Australia and New Zealand) enhancing its worldwide popularity.

Model history

GS500 engineering lineage descends directly from Suzuki's first modern 4-stroke motorcycles. With the 1976 debut of the GS750 air-cooled inline-four, as well as the GS400 parallel-twin, Suzuki was building 4-stroke engines despite having produced only 2-stroke motors for 20 years. The Suzuki GS series soon expanded into larger and smaller four-cylinder bikes, the GS1000 and GS550 respectively, while the twin-cylinder engine was bored-out to become the GS425 twin. All of these models preserved the earliest GS engine layout: double overhead cams, 2 shim-adjusted valves per cylinder and a roller-bearing crankshaft.

GS500E inline four 1979-1982

The GS500E motorcycle appeared in 1979, powered by a sleeved-down version of the GS550 engine (with smaller carburetors). The GS500E four was manufactured for markets where its smaller displacement was suited to insurance or license regulations.
GS500E parallel twin 1988-2000

Suzuki modified the original GS series engine layout to produce a successor to the GS425, the GS450 twin, which had a new bottom-end design that used a one-piece 180° crankshaft running on plain bearings. A counterbalance shaft controlled engine vibrations. The 448 cubic centimetres (27.3 cu in) displacement of this twin grew to 487 cubic centimetres (29.7 cu in) in 1988 by means of a 3 mm larger bore, when it became the engine for the new GS500E.

Although the GS500E twin was developed from an existing design, for the 1988 GS500EJ model Suzuki came up with a brand new frame, running gear and bodywork aimed at urban riders, novice motorcyclists and those on a budget. Additionally, the GS500EJ debuted with carburetors from the Mikuni ‘Slingshot’ series, a design which was simultaneously being used on the Suzuki GSX-R750 racer-replica. Although it did not produce as much horsepower as comparable multivalve engines, the two-valve GS500 engine had proportionally more torque at low speeds.

As introduced in 1988 for the UK, and the GS500EK model in 1989 for Europe and North America, the bike came with a black painted engine mounted in a light grey frame and white wheels. These first GS500 bikes had low two-piece handlebars, giving the impression of clip-ons but were in fact mounted to the upper triple tree. In 1990 the handlebars were raised to a more standard height. A California-specific model for 1990 had a reduced fuel capacity, 15.0 liters (3.3 imp gal; 4.0 U.S. gal) instead of 17 liters, to allow room under the tank for an evaporation canister.

The GS500EN (1992) front suspension was improved by fitting spring preload adjusters to the forks. The painted wheels were changed in 1996 from the original white color to dark grey, and the frame on some models.

The engine was no longer painted black.
New front brake calipers for the GS500EV in 1997 had two large pistons, replacing the previous unequally-sized pistons. Starting in 1998 (GS500EW) French models were fitted with Mikuni BSR 34mm carburetors with a three-circuit design (pilot jet, mid-main jet, main jet) for precise fuel metering throughout the rev range.
GS500 2001—2016


In 2001 the GS500 was given new bodywork and a 20-liter fuel tank. Wheel rims were painted light gray. All markets got the Mikuni BSR 34mm carburetors that had been used only on French models. Pulsed secondary air injection was used to reduce emissions. In addition to dropping the 'E' designation for the GS500, all Suzuki motorcycles went from using a single letter code for the model year (e.g., 'X' for 1999) to a letter-and-number code: K1 for 2001, K2 for 2002, L0 for 2010 and so on. In 2002 the wheel color became black, and from 2004 the frame was also painted black.

After 2002 Suzuki stopped producing the GS500E for the US market and did not release a GS500 for 2003. In 2007, Suzuki dropped the GS500 from its lineup in the UK and Spain, but it continued to be sold in some other countries.[10]
As of 2016, Suzuki Motor Corporation is producing the GS500 at its Latin American manufacturing subsidiary Suzuki Motor de Colombia S.A. for sale in Colombia and for export to Chile (where it is marketed as a retro model) as well as to Ecuador,

GS500F 2004-2013

In 2004, after a year hiatus, Suzuki came out with the GS500F to fill the void left (in the US market) by the GS500. In other countries the two models were sold side-by-side. This bike was very similar to the previous model, but came with a fully enclosed fairing, and the engine could be restricted for use in countries where restrictive motorcycle licenses are issued. The fairing offered a sportier, aggressive look and improved rider comfort by providing wind protection and better aerodynamics. An engine oil cooler was also added to improve reliability, and European models used a catalytic converter as well as pulsed secondary air injection to control emissions. The GS500F was dropped from the UK Suzuki range in 2007 and from the US range after 2009 model year, but was still available in Australia and Denmark.